Plug made of a white semi hard plastic with a tip of swellable polymers. The ribbed structure of the plug provides a first barrier against water ingress while the swelling of the tip when in contact with water will provide as secondary barrier.
Note : the following is a typical application description. In case of other jobsite parameters, please contact our technical department.
Hammer
Clean the surfaces of the spacer from dust, oil patches and other debris by brushing or compressed air.
PREPARATION OF THE PRODUCT SPETEC® PLUG is ready for use.
Simply position the plug on the opening of the spacer with the blue head facing towards the opening. Gently hammer the plug into the hole. No additional finishing is required.
No additional finishing is required.
SPETEC® PLUG can be applied under all weather conditions.
It’s recommended to contact the SPETEC® representative in case of special applications.
Round, white semi-hard plastic with a blue tip of swellable polymer.
1 plug per end of a spacer.
Property
|
Value
|
Diameter | 22, 24, 26, 32, 34 mm |
Pressure Resistance
|
6 bar
|
Expansion of the tip
|
up to 800% (after 5 days)
|
Diameter in mm
|
pieces/bag
|
pieces/box
|
22 | 100 | 1000 |
24 | 100 | 500 |
26 | 100 | 500 |
32 | 100 | 500 |
34 | 100 | 500 |
SPETEC® PLUG should be stored under cover, clear of the ground. Protect the materials from all sources of moisture and frost. Storage temperature must be between +5°C and +30°C Shelf life is unlimited in correct storage conditions.
Always use personal protective equipment in compliance with local regulations. Read the relevant Material Safety Data Sheet before use. Material Safety Data Sheets are available on www.spetec.com. When in doubt contact SPETEC® Technical Service.