PRODUCT DATA
THORMAJOINT™ BRIDGE JOINT BINDER
BJ200 Red
ThormaJoint™ is a high-performance bridge joint system of the category ‘Flexible Plug Expansion Joint’. It is designed for use on highway bridges and has a movement range of ±25mm. It is available in a range of grades to cover all climate conditions. The range of ThormaJoint™ grades includes the following:
TEMPERATE AND COLD CLIMATE GRADES | TROPICAL GRADES |
BJ200 Green | BJ200 Red |
BJ Super EX | BJ200ST |
BJ200 Blue | BJ300 Tropical |
BJ200 Red is a polymer modified bituminous compound used as a binder system in flexible plug expansion joints. BJ200 Red is a general-purpose grade ideal for use in locations with hot climates. It produces a stable and deformation resistant joint running surface whilst at the same time providing good movement capability for the expansion and contraction of the bridge joint.
Installation shall be carried out by experienced and trained crews approved by Ennis Flint. Installation shall be carried out according to Ennis Flint guidelines and method statement. A copy of this document is available on request.
The product data offered herein is, to the best of our knowledge, true and accurate, but all recommendations are made without warranty, expressed or implied. Because the conditions of use are beyond our control, neither Ennis-Flint nor its agents shall be liable for any injury, loss or damage, direct or consequential, arising from the use or the inability to use the product described herein. As Ennis-Flint has neither control over the
installation of product described herein nor control of the environmental factors the installed markings are subjected to, there is no guarantee as to the durability or the retroreflective properties of any marking system
applied. No person is authorized to make any statement or recommendation not contained in the Product Data, and any such statement or recommendation, if made, shall not bind the Corporation. Further, nothing contained herein shall be construed as a recommendation to use any product in conflict with existing patents, and no license under the claims of any patent is either implied or granted
info@ennisflint.com +44 (0) 1257 225 100 www.ennisflint.com
Data 12H Version 2 Jan 2018
© Ennis-Flint All Rights Reserved
PRODUCT DATA
Thormajoint™ may be installed as new works or as a maintenance solution for worn out or damaged joints. For new works or existing bridges where the surfacing has been renewed, the surfacing shall be applied to the bridge deck including the bridge gap. After compaction and cooling the asphalt shall be removed over the expansion gap (usually to a width of 500 mm) to allow installation of the flexible plug joint.
For replacement of existing joints, often the concrete and asphalt becomes damaged as a result of the removal process. Care should be taken to ensure the joint recess is restored to good condition before filling with the new joint.
TEST | TEST METHOD | TYPICAL TEST RESULT | EF SPECIFICATION |
Softening point (°C) |
EN 1427: 2000 | 100 | > 95 |
Specific gravity |
In-house method | 1.35 | 1.35 ± 0.1 |
Cone penetration (dmm) at 25°C |
EN 13880-2: 2003 | 20 | 10 – 30 |
Plate flow (mm) | EN 13880-5: 2004 | 0 | 0 |
Extension / Bond test (50%) at 25°C | ASTM D5329 | 3/3 Passes | 3/3 Passes |
BJ200 Red is supplied in block form in 4-ply sacks holding approximately 18 kg of material. Keep in dry storage under cover. BJ200 Red has a shelf life in excess of 24 months. Safe Handling Precautions